Reconfiguring your bar code scanner

Pear Tree
2016-11-10 15:47

Re-configuring Your Bar Code Scanner

 

If you try scanning a bar code and it does not work, you might need to re-configure your scanner.  Here’s how:

 

  1. Find your MetroSelect Single-Line Configuration Guide.
  2. Scan the Recall Default bar code on page 2 of the guide or scan the bar code below:

image001.gif

  1. Try the original bar code that would not scan again.  It should now scan.

 

  1. If the bar code still does not scan, scan Code 39 on page 4 of the configuration guide.

image002.gif

 

  1. Try the original bar code again.
  2. If the bar code still does not scan, please contact Peartree Software at 519-743-2444 or toll free at 1-877-862-7327.

 

Average rating: 0 (0 Votes)

You cannot comment on this entry